Varidesk Flexispot – 77% OFF Today Only

Flexispot Standing Desk Evaluation …Varidesk Flexispot…

Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are minimal, here are a few features that I wasn’t necessarily a big fan of:

The plan that the desk can be found in was heavy, so bringing it inside was a group effort, but this is just a consequence of how tough the Flexispot is.
The practical cable television tray was a little bit complicated to install. In the end, you eventually slip it under screws, which wasn’t extremely clear from the instructions.
You will need to purchase an anti-fatigue mat to remain comfy, but this is a great concept for any standing desks, so I can’t fault Flexispot for that.

When it got here and I saw how heavy it was, I was both excited (since this implied it was going to be strong) and likewise a little hesitant (because we all understand how much of an obstacle assembling furnishings can be).

Luckily, with the help of an instructional YouTube link, it took me only around 42 minutes to put together. Scratch that, it took my 11-year-old daughter, with some guidance from me, from start to finish. The only problem I have with assembly was the cable tray, which I found wasn’t discussed well in the directions.

When assembled, I love the streamlined look of this desk. I’m confident any of the many varied surfaces that it can be found in would look great in any office, and the adjustable width makes it easy to fit it in even the tiniest of office.

The peaceful operation and height memory settings make it simple, efficient, and peaceful to switch in between sitting and standing as many times as you desire throughout the day.

This desk is durable. It can hold up to 335 lbs even while in operation, so if you have a large desktop (or wish to rest on it for some reason) it has you covered. It will likewise equally disperse weight no matter how unbalanced the weight you place on it is, it will not wiggle or wobble.

 

because video is pretty kitted out as the desk we’re taking a look at today is quite standard I attempted to get as close to that as I could on uplifts website with equivalent setups the flexi spot desk we’re looking at today will run you about four hundred and 10 dollars versus 6 hundred and fifty for a comparable desk from uplift I try to get as close as possible with the uplift model is in fact 5 inches longer but you can do a lot with 5 inches boom yes now for openness flexi spot did send this desk out for review but as you should understand by now does not affect my evaluation in any way the desktop here is 55 inches wide 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not shipping up until completion of April at the earliest the desktop is an inch thick but it’s this standard laminate as you can possibly get doing not have even any cable television grommets for travel through the outdoors carton

for the desktop was not damaged in any way which is entirely strange since I could shoot a 30-second b-roll montage of just the damage and defects on this desktop scuffed scraped pitted simply extremely rough male if I had purchased this I ‘d have been on the phone with customer service immediately they did also managed to miss drilling the pilot holes where you can connect the control box to the desktop a lot of having to do that myself without unintentionally drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be connecting the surface area to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from having to drill that top was really quite straightforward the entire thing came together in about 45 minutes and despite the fact that there’s cable televisions running to it from each part to support motorized function strangely absolutely where any sort of cable television management products whatsoever the frame on this unit is a single motor dual stage design versus the double motor three-stage style that comes requirement with the uplift desk this can be upgraded as well to both the double phase double motor and a three-stage double motor which pushes the cost of the desk up

an extra 70 bucks the frame is created for a max load of 154 pounds and it moves at a rate at an inch per second the height can range from just under 28 inches to simply over forty seven point six inches so a max I ‘d it is more than high sufficient even for me and I remain at 6 foot for this design does come standard with the control panel that permits up-and-down motion plus 3 memory spots with an LED readout to inform you the desk height the single motor style uses this drive shaft assembly which needs to be adjusted as the width of the desk is adjusted the motor operation itself while it might be sluggish is really quiet as in barely audible this outside a cost would be the one benefit I would offer this system over the uplift desk and I want to be careful here because this isn’t a hit piece this desk is 240 dollars cheaper than the comparable uplift model over 35% more affordable even if you upgrade this flexi spot test to the dual motor three-stage design it still can be found in a hundred and seventy dollars less expensive than the uplift but more affordable does not indicate cheap this desk is still over four hundred dollars if I had actually paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is solid even if max height I’ll absolutely give it that but the lateral stability of this desk the horizontal motion at this rate point it’s unacceptable it’s add fuel to the fire here they consist of a little safety baffle this little steel piece that installs to the frame and covers a part of this turning driveshaft when

this desk sees any lateral movement at all the drive shaft hits this baffle and the sound is definitely shocking to top things off I decided to include rolling casters to this desk this was a $30 upgrade and two of those four casters got here harmed as well my plan for this desk at this point is to lose the desk top and came with entirely and change it with a white laminate lemon table from Ikea and use it as an adjustable picture table which you can’t do this frame will accommodate desktops approximately 63 inches wide and 31 and a half inches deep so this will roll around the studio make it easier to film products without having to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift first that is an investment in quality office furniture that will last you this at finest feels like a more affordable imitation of that it simply doesn’t feel quality and the difference between this desk and my primary desk is night and day do do not hesitate to take a look at their site as well which likewise feels eerily comparable to one of their rivals there’s a wealth of devices you can get for the flexi spot desk up to and including a foot massager and even a fixed exercise bike and I might spend another 10 minutes of our precious time covering various alternatives and devices I could however I think I’m happier that they just sent a basic desk since as a standard desk I’m not a fan of the quality assurance at this price point and I do not believe slapping on a lot of extras is the relocation when the core product isn’t what it should be they do offer a 30-day trial if you’re simply morbidly curious and they warranty their desks for three years very desk is 5 years and uplift desk is 7 years if you are Varidesk Flexispot

in the market for a sit-stand desk they’re remarkable mine’s been a life changer for me both in regards to gaming and performance however I would invest the extra money it’s gon na require to get into a greater end maker like uplift desk or really desk and I have not personally utilized very desk items so I can’t speak on it but their reputation is very good huge thanks to flexi spot for sending this out for evaluation regrettably I can not advise this unit and for the record I’m a hundred percent sure they would have happily replaced the parts that I had a problem with seeing as how both the desktop and the casters showed up harmed however from a client perspective you ‘d most likely be really thrilled to get this in