Flexispot Vs Ergotron – 77% OFF Today Only

Flexispot Standing Desk Evaluation …Flexispot Vs Ergotron…

Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are minimal, here are a couple of features that I wasn’t necessarily a substantial fan of:

The bundle that the desk can be found in was heavy, so bringing it inside was a group effort, however this is simply a repercussion of how tough the Flexispot is.
The hassle-free cable television tray was a little bit complicated to install. In the end, you eventually slip it under screws, which wasn’t really clear from the instructions.
You will need to purchase an anti-fatigue mat to stay comfy, but this is a great concept for any standing desks, so I can’t fault Flexispot for that.

When it showed up and I saw how heavy it was, I was both ecstatic (given that this suggested it was going to be sturdy) and likewise a little reluctant (since we all understand how much of a difficulty assembling furnishings can be).

Fortunately, with the help of an instructional YouTube link, it took me just around 42 minutes to put together. Scratch that, it took my 11-year-old child, with some supervision from me, from start to finish. The only hang-up I have with assembly was the cable tray, which I discovered wasn’t explained well in the directions.

When put together, I like the sleek appearance of this desk. I’m confident any of the many varied finishes that it can be found in would look great in any workplace, and the adjustable width makes it easy to fit it in even the tiniest of home offices.

The quiet operation and height memory settings make it easy, efficient, and quiet to switch in between sitting and standing as many times as you want throughout the day.

This desk is tough. It can hold up to 335 lbs even while in operation, so if you have a significant desktop (or wish to rest on it for some reason) it has you covered. It will also evenly disperse weight no matter how unbalanced the weight you put on it is, it will not wiggle or wobble.

 

because video is pretty kitted out as the desk we’re taking a look at today is pretty basic I attempted to get as near that as I could on uplifts website with equivalent configurations the flexi area desk we’re looking at today will run you about four hundred and ten dollars versus six hundred and fifty for a comparable desk from uplift I attempt to get as close as possible with the uplift design is actually 5 inches longer however you can do a lot with 5 inches boom yes now for openness flexi area did send this desk out for review but as you need to know by now does not impact my review in any way the desktop here is 55 inches large 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming however it’s not delivering till completion of April at the earliest the desktop is an inch thick but it’s this standard laminate as you can possibly get doing not have even any cable grommets for pass through the outside container

for the desktop was not harmed in any way which is entirely bizarre since I could shoot a 30-second b-roll montage of just the damage and defects on this desktop scuffed scraped pitted simply extremely rough man if I had actually bought this I ‘d have been on the phone with client service instantly they did also managed to miss drilling the pilot holes where you can attach the control box to the desktop a great deal of having to do that myself without accidentally drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be connecting the surface area to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was actually quite uncomplicated the whole thing came together in about 45 minutes and despite the fact that there’s cables running to it from each part to support motorized function strangely definitely where any type of cable management products whatsoever the frame on this unit is a single motor double stage style versus the double motor three-stage design that comes requirement with the uplift desk this can be upgraded also to both the dual phase dual motor and a three-stage dual motor which pushes the cost of the desk up

an extra 70 bucks the frame is designed for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can vary from just under 28 inches to just over forty 7 point six inches so a max I ‘d it is more than high enough even for me and I remain at 6 foot for this design does come basic with the control board that enables up-and-down motion plus 3 memory spots with an LED readout to inform you the desk height the single motor style utilizes this drive shaft assembly which has to be adjusted as the width of the desk is changed the motor operation itself while it might be slow is very peaceful as in barely audible this outside a rate would be the one benefit I would provide this system over the uplift desk and I want to be careful here because this isn’t a hit piece this desk is 240 dollars cheaper than the similar uplift design over 35% more affordable even if you upgrade this flexi area test to the dual motor three-stage design it still comes in a hundred and seventy dollars cheaper than the uplift however more affordable does not indicate cheap this desk is still over four hundred dollars if I had paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is strong even if max height I’ll definitely provide it that however the lateral stability of this desk the horizontal movement at this price point it’s inappropriate it’s add fuel to the fire here they consist of a little safety baffle this little steel piece that installs to the frame and covers a portion of this turning driveshaft when

this desk sees any lateral movement at all the drive shaft hits the noise and this baffle is absolutely shocking to top things off I decided to include rolling casters to this desk this was a $30 upgrade and two of those four casters got here damaged also my plan for this desk at this moment is to lose the desk top and featured entirely and change it with a white laminate lemon table from Ikea and use it as an adjustable picture table which you can’t do this frame will accommodate desktops up to 63 inches large and 31 and a half inches deep so this will roll around the studio make it much easier to film products without having to adjust complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I found uplift first that is an investment in quality workplace furniture that will last you this at best seems like a cheaper imitation of that it simply doesn’t feel quality and the distinction between this desk and my main desk is night and day do do not hesitate to take a look at their website too which likewise feels strangely similar to among their rivals there’s a wealth of accessories you can get for the flexi spot desk up to and including a foot massager and even a stationary exercise bike and I could invest another 10 minutes of our valuable time covering various choices and accessories I might however I think I’m better that they just sent out a standard desk because as a standard desk I’m not a fan of the quality assurance at this cost point and I do not think slapping on a lot of additionals is the move when the core product isn’t what it must be they do use a 30-day trial if you’re simply morbidly curious and they warranty their desks for three years very desk is five years and uplift desk is seven years if you are Flexispot Vs Ergotron

in the market for a sit-stand desk they’re amazing mine’s been a life changer for me both in regards to gaming and efficiency however I would invest the extra money it’s gon na require to enter a higher end manufacturer like uplift desk or really desk and I have not personally utilized very desk items so I can’t speak on it but their credibility is excellent huge thanks to flexi spot for sending this out for review unfortunately I can not advise this system and for the record I’m a hundred percent sure they would have happily replaced the parts that I had a problem with viewing as how both the desktop and the casters showed up harmed however from a consumer standpoint you ‘d most likely be actually thrilled to get this in