Flexispot Video – 77% OFF Today Only

Flexispot Standing Desk Evaluation …Flexispot Video…

Cons: What I Didn’t Like About the Flexispot E7
Though the cons on this desk are minimal, here are a few functions that I wasn’t always a substantial fan of:

The package that the desk can be found in was heavy, so bringing it inside was a group effort, however this is just a repercussion of how sturdy the Flexispot is.
The practical cable tray was a little bit complicated to install. In the end, you eventually slip it under screws, which wasn’t very clear from the instructions.
You will need to buy an anti-fatigue mat to remain comfy, but this is a great concept for any standing desks, so I can’t fault Flexispot for that.

When it arrived and I saw how heavy it was, I was both thrilled (given that this indicated it was going to be tough) and also a little reluctant (because we all understand just how much of an obstacle putting together furnishings can be).

The good news is, with the help of an educational YouTube link, it took me just around 42 minutes to put together. Scratch that, it took my 11-year-old child, with some supervision from me, from start to finish. The only hang-up I have with assembly was the cable tray, which I found wasn’t described well in the instructions.

As soon as assembled, I enjoy the smooth appearance of this desk. I’m confident any of the many varied surfaces that it comes in would look fantastic in any office, and the adjustable width makes it simple to fit it in even the smallest of home offices.

The peaceful operation and height memory settings make it simple, efficient, and quiet to switch between sitting and standing as many times as you desire throughout the day.

This desk is strong. It can hold up to 335 pounds even while in operation, so if you have a significant home computer (or wish to sleep on it for some reason) it has you covered. It will also uniformly disperse weight no matter how out of balance the weight you put on it is, it won’t wiggle or wobble.

 

because video is quite kitted out as the desk we’re taking a look at today is pretty standard I attempted to get as near to that as I might on uplifts site with equivalent configurations the flexi area desk we’re looking at today will run you about four hundred and ten dollars versus six hundred and fifty for a similar desk from uplift I attempt to get as close as possible with the uplift model is in fact 5 inches longer but you can do a lot with five inches boom yes now for openness flexi spot did send this desk out for evaluation however as you need to know by now does not affect my review in any way the desktop here is 55 inches broad 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming however it’s not delivering up until completion of April at the earliest the desktop is an inch thick but it’s this standard laminate as you can possibly get doing not have even any cable grommets for travel through the outside container

for the desktop was not harmed in any way which is entirely strange because I might shoot a 30-second b-roll montage of just the damage and flaws on this desktop scuffed scraped pitted just incredibly rough male if I had bought this I ‘d have been on the phone with customer care right away they did also handled to miss out on drilling the pilot holes where you can connect the control box to the desktop a great deal of needing to do that myself without accidentally drilling through the opposite of the desktop so yeah pilot holes in wood screws is how you’re gon na be connecting the surface area to the frame that’s a far cry from the embedded metal inserts that we saw on the uplift desk so assembly aside from having to drill that top was actually quite uncomplicated the whole thing came together in about 45 minutes and despite the fact that there’s cable televisions running to it from each part to support motorized function strangely definitely where any sort of cable television management materials whatsoever the frame on this unit is a single motor double stage design versus the double motor three-stage design that comes standard with the uplift desk this can be upgraded too to both the dual phase dual motor and a three-stage dual motor which presses the cost of the desk up

an additional 70 dollars the frame is designed for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can range from just under 28 inches to simply over forty seven point six inches so a max I ‘d it is more than tall adequate even for me and I remain at 6 foot for this model does come standard with the control panel that permits up-and-down motion plus three memory areas with an LED readout to inform you the desk height the single motor design utilizes this drive shaft assembly which needs to be adjusted as the width of the desk is adjusted the motor operation itself while it might be slow is very peaceful as in barely audible this outside a price would be the one advantage I would offer this unit over the uplift desk and I want to take care here because this isn’t a hit piece this desk is 240 dollars cheaper than the similar uplift design over 35% cheaper even if you upgrade this flexi spot test to the double motor three-stage design it still is available in a hundred and seventy dollars cheaper than the uplift but more affordable does not indicate low-cost this desk is still over four hundred dollars if I had actually paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is solid even if max height I’ll definitely provide it that however the lateral stability of this desk the horizontal movement at this rate point it’s undesirable it’s add fuel to the fire here they include a little security baffle this little steel piece that mounts to the frame and covers a portion of this rotating driveshaft when

this desk sees any lateral movement at all the drive shaft hits this baffle and the sound is definitely frustrating to top things off I decided to include rolling casters to this desk this was a $30 upgrade and 2 of those four casters got here harmed also my plan for this desk at this point is to lose the desk top and featured entirely and replace it with a white laminate lemon table from Ikea and use it as an adjustable image table which you can’t do this frame will accommodate desktops up to 63 inches broad and 31 and a half inches deep so this will roll around the studio make it simpler to movie products without needing to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift initially that is a financial investment in quality workplace furniture that will last you this at best seems like a less expensive replica of that it simply does not feel quality and the difference between this desk and my primary desk is night and day do feel free to have a look at their website as well which likewise feels strangely comparable to among their rivals there’s a wealth of accessories you can get for the flexi area desk up to and including a foot massager and even a stationary exercise bike and I could invest another 10 minutes of our valuable time covering various choices and devices I might however I believe I’m happier that they only sent out a basic desk due to the fact that as a standard desk I’m not a fan of the quality assurance at this rate point and I don’t think slapping on a lot of extras is the relocation when the core item isn’t what it should be they do use a 30-day trial if you’re just morbidly curious and they service warranty their desks for three years really desk is 5 years and uplift desk is seven years if you are Flexispot Video

in the market for a sit-stand desk they’re amazing mine’s been a life changer for me both in terms of gaming and performance however I would invest the additional money it’s gon na take to enter a higher end manufacturer like uplift desk or really desk and I have not personally utilized really desk products so I can’t speak on it however their credibility is very good huge thanks to flexi spot for sending this out for review unfortunately I can not suggest this unit and for the record I’m a hundred percent sure they would have gladly replaced the parts that I had a problem with seeing as how both the desktop and the casters arrived damaged however from a client perspective you ‘d most likely be really excited to get this in