Flexispot Vici – 77% OFF Today Only

Flexispot Standing Desk Evaluation …Flexispot Vici…

Cons: What I Didn’t Like About the Flexispot E7
Though the cons on this desk are minimal, here are a couple of features that I wasn’t always a huge fan of:

The bundle that the desk was available in was heavy, so bringing it inside was a group effort, but this is just an effect of how tough the Flexispot is.
The convenient cable television tray was a bit complicated to install. In the end, you ultimately slip it under screws, which wasn’t very clear from the directions.
You will need to buy an anti-fatigue mat to remain comfy, but this is an excellent idea for any standing desks, so I can’t fault Flexispot for that.

When it showed up and I saw how heavy it was, I was both thrilled (considering that this indicated it was going to be tough) and also a little reluctant (since we all understand just how much of a difficulty assembling furniture can be).

Fortunately, with the help of an instructional YouTube link, it took me only around 42 minutes to put together. Scratch that, it took my 11-year-old child, with some guidance from me, from start to finish. The only problem I have with assembly was the cable tray, which I found wasn’t discussed well in the directions.

Once put together, I like the smooth appearance of this desk. I’m confident any of the many varied finishes that it can be found in would look terrific in any office, and the adjustable width makes it simple to fit it in even the smallest of home offices.

The quiet operation and height memory settings make it simple, efficient, and quiet to switch in between sitting and standing as lot of times as you want throughout the day.

Finally, this desk is durable. It can hold up to 335 lbs even while in operation, so if you have a substantial desktop computer (or want to take a nap on it for some reason) it has you covered. It will likewise evenly disperse weight no matter how unbalanced the weight you place on it is, it will not wiggle or wobble.

 

in that video is pretty kitted out as the desk we’re taking a look at today is quite fundamental I attempted to get as close to that as I might on uplifts site with similar configurations the flexi spot desk we’re taking a look at today will run you about four hundred and ten dollars versus 6 hundred and fifty for a similar desk from uplift I try to get as close as possible with the uplift model is in fact 5 inches longer but you can do a lot with 5 inches boom yes now for openness flexi area did send this desk out for evaluation but as you must understand by now doesn’t impact my review in any way the desktop here is 55 inches large 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming however it’s not delivering until the end of April at the earliest the desktop is an inch thick but it’s this basic laminate as you can possibly get lacking even any cable television grommets for pass through the outdoors carton

for the desktop was not harmed in any way which is utterly bizarre due to the fact that I might shoot a 30-second b-roll montage of just the damage and flaws on this desktop scuffed scraped pitted just extremely rough male if I had acquired this I ‘d have been on the phone with client service right away they did likewise managed to miss drilling the pilot holes where you can connect the control box to the desktop a great deal of having to do that myself without unintentionally drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be connecting the surface to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was actually quite simple the whole thing came together in about 45 minutes and despite the fact that there’s cable televisions going to it from each element to support motorized function strangely definitely where any sort of cable television management products whatsoever the frame on this system is a single motor double phase style versus the dual motor three-stage style that comes standard with the uplift desk this can be upgraded as well to both the dual stage double motor and a three-stage dual motor which presses the cost of the desk up

an additional 70 bucks the frame is designed for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can vary from simply under 28 inches to simply over forty 7 point 6 inches so a max I ‘d it is more than tall enough even for me and I remain at 6 foot for this design does come basic with the control panel that allows for up-and-down motion plus three memory spots with an LED readout to tell you the desk height the single motor design utilizes this drive shaft assembly which has to be changed as the width of the desk is changed the motor operation itself while it might be slow is very peaceful as in barely audible this outside a cost would be the one benefit I would give this unit over the uplift desk and I want to be careful here due to the fact that this isn’t a hit piece this desk is 240 dollars less expensive than the similar uplift design over 35% cheaper even if you update this flexi area test to the dual motor three-stage design it still is available in a hundred and seventy dollars more affordable than the uplift however cheaper does not imply inexpensive this desk is still over four hundred dollars if I had paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is strong even if max height I’ll definitely provide it that but the lateral stability of this desk the horizontal movement at this rate point it’s unacceptable it’s rub salt in the wound here they include a little safety baffle this little steel piece that installs to the frame and covers a portion of this rotating driveshaft when

this desk sees any lateral motion at all the drive shaft strikes the sound and this baffle is absolutely frustrating to top things off I decided to include rolling casters to this desk this was a $30 upgrade and 2 of those four casters arrived harmed also my plan for this desk at this moment is to lose the desk top and featured entirely and replace it with a white laminate lemon table from Ikea and use it as an adjustable picture table which you can’t do this frame will accommodate desktops approximately 63 inches wide and 31 and a half inches deep so this will roll around the studio make it easier to film items without having to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift first that is a financial investment in quality office furniture that will last you this at finest seems like a more affordable replica of that it just does not feel quality and the distinction in between this desk and my main desk is night and day do feel free to take a look at their website also which also feels eerily comparable to among their rivals there’s a wealth of devices you can get for the flexi spot desk as much as and consisting of a foot massager and even a stationary stationary bicycle and I could invest another 10 minutes of our precious time covering various options and devices I might but I believe I’m better that they just sent a standard desk because as a basic desk I’m not a fan of the quality assurance at this cost point and I do not believe slapping on a lot of extras is the move when the core item isn’t what it need to be they do use a 30-day trial if you’re simply morbidly curious and they service warranty their desks for 3 years very desk is 5 years and uplift desk is 7 years if you are Flexispot Vici

in the market for a sit-stand desk they’re amazing mine’s been a life changer for me both in terms of gaming and performance but I would spend the money it’s gon na take to enter into a higher end producer like uplift desk or really desk and I have not personally utilized very desk products so I can’t speak on it but their reputation is great big thanks to flexi spot for sending this out for evaluation unfortunately I can not advise this unit and for the record I’m a hundred percent sure they would have gladly replaced the parts that I had a concern with viewing as how both the desktop and the casters got here damaged however from a client perspective you ‘d probably be really delighted to get this in