Flexispot Vici Desk – 77% OFF Today Only

Flexispot Standing Desk Review …Flexispot Vici Desk…

Cons: What I Didn’t Like About the Flexispot E7
Though the cons on this desk are very little, here are a couple of functions that I wasn’t necessarily a big fan of:

The package that the desk came in was heavy, so bringing it inside was a group effort, but this is simply an effect of how tough the Flexispot is.
The practical cable tray was a little bit complicated to install. In the end, you eventually slip it under screws, which wasn’t very clear from the guidelines.
You will need to purchase an anti-fatigue mat to stay comfortable, however this is a good idea for any standing desks, so I can’t fault Flexispot for that.

When it showed up and I saw how heavy it was, I was both fired up (given that this indicated it was going to be durable) and also a little hesitant (since we all know just how much of a challenge assembling furniture can be).

Fortunately, with the help of an instructional YouTube link, it took me just around 42 minutes to put together. Scratch that, it took my 11-year-old child, with some supervision from me, from start to finish. The only problem I have with assembly was the cable tray, which I discovered wasn’t explained well in the instructions.

When assembled, I like the smooth look of this desk. I’m positive any of the many diverse surfaces that it can be found in would look terrific in any workplace, and the adjustable width makes it easy to fit it in even the tiniest of home offices.

The peaceful operation and height memory settings make it simple, effective, and peaceful to switch in between sitting and standing as many times as you desire throughout the day.

This desk is strong. It can hold up to 335 lbs even while in operation, so if you have a hefty desktop computer (or want to take a nap on it for some reason) it has you covered. It will also equally disperse weight no matter how unbalanced the weight you put on it is, it won’t wobble or wiggle.

 

because video is quite kitted out as the desk we’re looking at today is quite basic I attempted to get as near that as I could on uplifts site with similar setups the flexi area desk we’re taking a look at today will run you about four hundred and 10 dollars versus six hundred and fifty for a comparable desk from uplift I attempt to get as close as possible with the uplift model is really five inches longer however you can do a lot with 5 inches boom yes now for openness flexi spot did send this desk out for review but as you ought to understand by now does not impact my review in any way the desktop here is 55 inches large 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming however it’s not delivering till the end of April at the earliest the desktop is an inch thick however it’s this fundamental laminate as you can perhaps get doing not have even any cable television grommets for pass through the outside container

for the desktop was not harmed in any way which is utterly strange since I could shoot a 30-second b-roll montage of just the damage and flaws on this desktop scuffed scraped pitted simply super rough guy if I had actually acquired this I ‘d have been on the phone with customer service instantly they did likewise handled to miss out on drilling the pilot holes where you can connect the control box to the desktop a great deal of having to do that myself without unintentionally drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface area to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was really quite straightforward the entire thing came together in about 45 minutes and despite the fact that there’s cable televisions running to it from each component to support motorized function unusually absolutely where any kind of cable management products whatsoever the frame on this system is a single motor double stage design versus the dual motor three-stage design that comes requirement with the uplift desk this can be upgraded too to both the double stage double motor and a three-stage dual motor which pushes the cost of the desk up

an extra 70 bucks the frame is created for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can range from just under 28 inches to just over forty seven point six inches so a max I ‘d it is more than high enough even for me and I stay at 6 foot for this design does come standard with the control panel that allows for up-and-down movement plus 3 memory areas with an LED readout to tell you the desk height the single motor design utilizes this drive shaft assembly which has to be changed as the width of the desk is adjusted the motor operation itself while it might be slow is very quiet as in barely audible this outside a cost would be the one benefit I would provide this system over the uplift desk and I want to take care here due to the fact that this isn’t a hit piece this desk is 240 dollars cheaper than the equivalent uplift model over 35% cheaper even if you upgrade this flexi area test to the dual motor three-stage design it still is available in a hundred and seventy dollars cheaper than the uplift however less expensive does not indicate low-cost this desk is still over four hundred dollars if I had paid over $400 for this desk I ‘d have an issue with that the front to back stability of this desk is solid even if max height I’ll absolutely provide it that however the lateral stability of this desk the horizontal motion at this rate point it’s undesirable it’s add insult to injury here they include a little safety baffle this little steel piece that mounts to the frame and covers a part of this rotating driveshaft when

this desk sees any lateral motion at all the drive shaft strikes this baffle and the noise is absolutely frustrating to top things off I chose to add rolling casters to this desk this was a $30 upgrade and two of those four casters arrived damaged too my plan for this desk at this point is to lose the desk top and featured completely and replace it with a white laminate lemon table from Ikea and utilize it as an adjustable image table which you can’t do this frame will accommodate desktops as much as 63 inches wide and 31 and a half inches deep so this will roll around the studio make it simpler to movie products without having to adjust complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift initially that is a financial investment in quality workplace furniture that will last you this at best seems like a cheaper imitation of that it simply does not feel quality and the difference in between this desk and my main desk is night and day do do not hesitate to take a look at their website also which also feels eerily similar to one of their rivals there’s a wealth of devices you can get for the flexi spot desk approximately and including a foot massager and even a stationary exercise bike and I could invest another 10 minutes of our valuable time covering numerous choices and accessories I might however I think I’m better that they just sent a basic desk because as a standard desk I’m not a fan of the quality control at this cost point and I do not believe slapping on a bunch of additionals is the relocation when the core product isn’t what it ought to be they do provide a 30-day trial if you’re just morbidly curious and they warranty their desks for 3 years very desk is 5 years and uplift desk is 7 years if you are Flexispot Vici Desk

in the market for a sit-stand desk they’re fantastic mine’s been a life changer for me both in regards to video gaming and performance however I would invest the money it’s gon na take to enter into a higher end maker like uplift desk or very desk and I haven’t personally used really desk products so I can’t speak on it however their track record is great big thanks to flexi spot for sending this out for evaluation regrettably I can not advise this system and for the record I’m a hundred percent sure they would have gladly replaced the parts that I had an issue with seeing as how both the desktop and the casters arrived damaged but from a customer viewpoint you ‘d probably be truly thrilled to get this in