Flexispot Theodore Desk – 77% OFF Today Only

Flexispot Standing Desk Evaluation …Flexispot Theodore Desk…

Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are very little, here are a couple of features that I wasn’t always a substantial fan of:

The package that the desk can be found in was heavy, so bringing it inside was a group effort, however this is simply a consequence of how sturdy the Flexispot is.
The practical cable tray was a bit complicated to install. In the end, you eventually slip it under screws, which wasn’t very clear from the directions.
You will require to buy an anti-fatigue mat to stay comfy, but this is an excellent concept for any standing desks, so I can’t fault Flexispot for that.

When it got here and I saw how heavy it was, I was both thrilled (considering that this meant it was going to be strong) and also a little reluctant (since we all understand just how much of a challenge putting together furnishings can be).

Luckily, with the help of an instructional YouTube link, it took me only around 42 minutes to assemble. Scratch that, it took my 11-year-old daughter, with some guidance from me, from start to finish. The only problem I have with assembly was the cable tray, which I found wasn’t discussed well in the instructions.

Once put together, I love the sleek look of this desk. I’m positive any of the many varied finishes that it is available in would look great in any office, and the adjustable width makes it easy to fit it in even the tiniest of office.

The peaceful operation and height memory settings make it easy, effective, and peaceful to switch in between sitting and standing as lot of times as you want throughout the day.

Last but not least, this desk is sturdy. It can hold up to 335 lbs even while in operation, so if you have a hefty home computer (or want to rest on it for some reason) it has you covered. It will likewise equally disperse weight no matter how out of balance the weight you put on it is, it won’t wiggle or wobble.

 

in that video is quite kitted out as the desk we’re looking at today is pretty standard I attempted to get as close to that as I might on uplifts site with similar setups the flexi area desk we’re looking at today will run you about four hundred and 10 dollars versus six hundred and fifty for a similar desk from uplift I attempt to get as close as possible with the uplift design is in fact 5 inches longer but you can do a lot with 5 inches boom yes now for transparency flexi spot did send this desk out for review but as you need to know by now doesn’t affect my evaluation in any way the desktop here is 55 inches wide 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not delivering up until completion of April at the earliest the desktop is an inch thick however it’s this basic laminate as you can possibly get doing not have even any cable grommets for go through the outside carton

for the desktop was not damaged in any way which is absolutely unusual since I could shoot a 30-second b-roll montage of simply the damage and flaws on this desktop scuffed scraped pitted just extremely rough male if I had actually purchased this I ‘d have been on the phone with customer support instantly they did likewise managed to miss out on drilling the pilot holes where you can attach the control box to the desktop a lot of needing to do that myself without accidentally drilling through the opposite of the desktop so yeah pilot holes in wood screws is how you’re gon na be connecting the surface area to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from having to drill that top was actually pretty straightforward the whole thing came together in about 45 minutes and despite the fact that there’s cable televisions going to it from each component to support motorized function unusually absolutely where any kind of cable television management products whatsoever the frame on this system is a single motor double phase style versus the double motor three-stage design that comes requirement with the uplift desk this can be updated as well to both the double stage dual motor and a three-stage dual motor which presses the expense of the desk up

an additional 70 dollars the frame is created for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can vary from simply under 28 inches to just over forty seven point 6 inches so a max I ‘d it is more than high sufficient even for me and I remain at 6 foot for this model does come standard with the control board that allows for up-and-down movement plus 3 memory areas with an LED readout to tell you the desk height the single motor design uses this drive shaft assembly which has to be changed as the width of the desk is changed the motor operation itself while it might be sluggish is really quiet as in barely audible this outside a rate would be the one advantage I would offer this unit over the uplift desk and I wish to be careful here due to the fact that this isn’t a hit piece this desk is 240 dollars cheaper than the equivalent uplift design over 35% less expensive even if you update this flexi area test to the dual motor three-stage style it still can be found in a hundred and seventy dollars more affordable than the uplift but less expensive doesn’t indicate inexpensive this desk is still over four hundred dollars if I had paid over $400 for this desk I ‘d have an issue with that the front to back stability of this desk is strong even if max height I’ll certainly provide it that however the lateral stability of this desk the horizontal motion at this rate point it’s undesirable it’s add fuel to the fire here they include a little safety baffle this little steel piece that mounts to the frame and covers a part of this turning driveshaft when

this desk sees any lateral movement at all the drive shaft strikes this baffle and the sound is definitely infuriating to leading things off I chose to include rolling casters to this desk this was a $30 upgrade and two of those 4 casters showed up damaged too my prepare for this desk at this point is to lose the desk top and included all together and replace it with a white laminate lemon table from Ikea and utilize it as an adjustable image table which you can’t do this frame will accommodate desktops up to 63 inches large and 31 and a half inches deep so this will roll around the studio make it easier to movie items without having to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I found uplift first that is a financial investment in quality office furniture that will last you this at finest feels like a less expensive replica of that it just doesn’t feel quality and the distinction in between this desk and my main desk is night and day do do not hesitate to have a look at their site also which likewise feels eerily similar to one of their rivals there’s a wealth of devices you can get for the flexi spot desk up to and including a foot massager and even a stationary exercise bike and I might invest another 10 minutes of our precious time covering numerous options and devices I could however I believe I’m better that they only sent out a fundamental desk due to the fact that as a fundamental desk I’m not a fan of the quality assurance at this price point and I don’t think slapping on a bunch of additionals is the move when the core product isn’t what it must be they do use a 30-day trial if you’re simply morbidly curious and they service warranty their desks for 3 years very desk is five years and uplift desk is 7 years if you are Flexispot Theodore Desk

in the market for a sit-stand desk they’re incredible mine’s been a life changer for me both in regards to gaming and efficiency but I would spend the extra money it’s gon na require to get into a greater end producer like uplift desk or very desk and I haven’t personally utilized very desk products so I can’t speak on it but their credibility is great big thanks to flexi spot for sending this out for review regrettably I can not suggest this unit and for the record I’m a hundred percent sure they would have gladly changed the parts that I had a problem with viewing as how both the desktop and the casters got here damaged but from a consumer viewpoint you ‘d probably be actually excited to get this in