Flexispot Standing Desk Mat – 77% OFF Today Only

Flexispot Standing Desk Review …Flexispot Standing Desk Mat…

Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are minimal, here are a couple of features that I wasn’t always a big fan of:

The bundle that the desk was available in was heavy, so bringing it inside was a group effort, but this is simply a consequence of how strong the Flexispot is.
The practical cable tray was a little bit complicated to set up. In the end, you eventually slip it under screws, which wasn’t really clear from the guidelines.
You will need to buy an anti-fatigue mat to stay comfy, but this is a good concept for any standing desks, so I can’t fault Flexispot for that.

When it got here and I saw how heavy it was, I was both fired up (since this implied it was going to be sturdy) and likewise a little reluctant (because all of us know just how much of an obstacle assembling furniture can be).

Fortunately, with the help of a training YouTube link, it took me only around 42 minutes to assemble. Scratch that, it took my 11-year-old daughter, with some guidance from me, from start to finish. The only hang-up I have with assembly was the cable television tray, which I found wasn’t described well in the directions.

When put together, I love the smooth appearance of this desk. I’m positive any of the many varied surfaces that it can be found in would look fantastic in any workplace, and the adjustable width makes it simple to fit it in even the smallest of home offices.

The quiet operation and height memory settings make it easy, effective, and quiet to change in between sitting and standing as sometimes as you desire throughout the day.

This desk is strong. It can hold up to 335 pounds even while in operation, so if you have a large home computer (or want to rest on it for some reason) it has you covered. It will likewise equally distribute weight no matter how unbalanced the weight you place on it is, it won’t wobble or wiggle.

 

in that video is quite kitted out as the desk we’re looking at today is pretty basic I attempted to get as near to that as I might on uplifts site with equivalent configurations the flexi spot desk we’re looking at today will run you about four hundred and ten dollars versus six hundred and fifty for a comparable desk from uplift I attempt to get as close as possible with the uplift model is in fact 5 inches longer but you can do a lot with 5 inches boom yes now for transparency flexi area did send this desk out for evaluation but as you need to understand by now does not impact my evaluation in any way the desktop here is 55 inches broad 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming however it’s not shipping up until the end of April at the earliest the desktop is an inch thick however it’s this standard laminate as you can possibly get doing not have even any cable television grommets for travel through the outdoors container

for the desktop was not damaged in any way which is entirely unusual because I could shoot a 30-second b-roll montage of just the damage and flaws on this desktop scuffed scraped pitted simply very rough male if I had actually purchased this I ‘d have been on the phone with client service instantly they did also managed to miss out on drilling the pilot holes where you can connect the control box to the desktop a lot of having to do that myself without accidentally drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was in fact quite simple the entire thing came together in about 45 minutes and despite the fact that there’s cables going to it from each element to support motorized function oddly absolutely where any type of cable television management materials whatsoever the frame on this unit is a single motor double stage style versus the dual motor three-stage design that comes standard with the uplift desk this can be updated as well to both the double stage dual motor and a three-stage double motor which pushes the cost of the desk up

an additional 70 bucks the frame is designed for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can vary from simply under 28 inches to simply over forty seven point 6 inches so a max I ‘d it is more than tall sufficient even for me and I stay at 6 foot for this model does come basic with the control board that enables up-and-down motion plus three memory spots with an LED readout to inform you the desk height the single motor style utilizes this drive shaft assembly which has to be adjusted as the width of the desk is changed the motor operation itself while it might be slow is very peaceful as in barely audible this outside a cost would be the one benefit I would offer this unit over the uplift desk and I want to beware here due to the fact that this isn’t a hit piece this desk is 240 dollars cheaper than the equivalent uplift model over 35% cheaper even if you upgrade this flexi spot test to the dual motor three-stage style it still comes in a hundred and seventy dollars more affordable than the uplift however less expensive does not suggest inexpensive this desk is still over four hundred dollars if I had actually paid over $400 for this desk I ‘d have an issue with that the front to back stability of this desk is strong even if max height I’ll certainly offer it that however the lateral stability of this desk the horizontal movement at this rate point it’s unacceptable it’s add insult to injury here they consist of a little safety baffle this little steel piece that mounts to the frame and covers a part of this rotating driveshaft when

this desk sees any lateral movement at all the drive shaft hits this baffle and the sound is definitely shocking to leading things off I chose to include rolling casters to this desk this was a $30 upgrade and 2 of those 4 casters arrived damaged also my prepare for this desk at this point is to lose the desk top and featured all together and change it with a white laminate lemon table from Ikea and utilize it as an adjustable picture table which you can’t do this frame will accommodate desktops as much as 63 inches broad and 31 and a half inches deep so this will roll around the studio make it easier to movie items without needing to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I found uplift initially that is an investment in quality workplace furnishings that will last you this at best feels like a cheaper imitation of that it simply does not feel quality and the distinction between this desk and my main desk is night and day do do not hesitate to take a look at their site also which also feels eerily comparable to among their competitors there’s a wealth of accessories you can get for the flexi spot desk approximately and including a foot massager and even a fixed stationary bicycle and I could invest another 10 minutes of our precious time covering numerous options and devices I might but I think I’m better that they only sent out a fundamental desk because as a fundamental desk I’m not a fan of the quality control at this price point and I don’t believe slapping on a lot of bonus is the move when the core item isn’t what it ought to be they do offer a 30-day trial if you’re just morbidly curious and they guarantee their desks for 3 years extremely desk is 5 years and uplift desk is seven years if you are Flexispot Standing Desk Mat

in the market for a sit-stand desk they’re amazing mine’s been a life changer for me both in regards to gaming and productivity however I would invest the extra money it’s gon na require to enter into a greater end producer like uplift desk or really desk and I have not personally utilized very desk products so I can’t speak on it but their reputation is excellent big thanks to flexi area for sending this out for review regrettably I can not suggest this system and for the record I’m a hundred percent sure they would have happily changed the parts that I had a problem with seeing as how both the desktop and the casters arrived harmed however from a consumer viewpoint you ‘d probably be actually delighted to get this in