Flexispot Standing Desk Gaming – 77% OFF Today Only

Flexispot Standing Desk Evaluation …Flexispot Standing Desk Gaming…

Cons: What I Didn’t Like About the Flexispot E7
Though the cons on this desk are minimal, here are a couple of features that I wasn’t necessarily a big fan of:

The package that the desk was available in was heavy, so bringing it inside was a group effort, however this is simply an effect of how sturdy the Flexispot is.
The convenient cable tray was a bit confusing to install. In the end, you eventually slip it under screws, which wasn’t extremely clear from the directions.
You will need to purchase an anti-fatigue mat to stay comfy, but this is a good idea for any standing desks, so I can’t fault Flexispot for that.

When it arrived and I saw how heavy it was, I was both fired up (considering that this indicated it was going to be strong) and likewise a little hesitant (due to the fact that we all understand just how much of a difficulty assembling furniture can be).

Thankfully, with the help of an educational YouTube link, it took me just around 42 minutes to assemble. Scratch that, it took my 11-year-old child, with some guidance from me, from start to finish. The only problem I have with assembly was the cable tray, which I found wasn’t explained well in the directions.

As soon as put together, I like the sleek appearance of this desk. I’m positive any of the many varied surfaces that it can be found in would look terrific in any office, and the adjustable width makes it easy to fit it in even the tiniest of office.

The quiet operation and height memory settings make it simple, efficient, and quiet to switch between sitting and standing as sometimes as you want throughout the day.

Lastly, this desk is tough. It can hold up to 335 pounds even while in operation, so if you have a hefty desktop (or want to take a nap on it for some reason) it has you covered. It will also uniformly distribute weight no matter how unbalanced the weight you put on it is, it will not wobble or wiggle.

 

in that video is pretty kitted out as the desk we’re looking at today is quite basic I attempted to get as near that as I could on uplifts site with comparable setups the flexi area desk we’re taking a look at today will run you about four hundred and ten dollars versus 6 hundred and fifty for a similar desk from uplift I attempt to get as close as possible with the uplift model is actually five inches longer however you can do a lot with five inches boom yes now for transparency flexi area did send this desk out for review but as you must know by now doesn’t impact my review in any way the desktop here is 55 inches broad 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not delivering until the end of April at the earliest the desktop is an inch thick however it’s this fundamental laminate as you can possibly get lacking even any cable television grommets for pass through the outside carton

for the desktop was not damaged in any way which is utterly bizarre due to the fact that I might shoot a 30-second b-roll montage of simply the damage and flaws on this desktop scuffed scraped pitted simply incredibly rough guy if I had actually purchased this I ‘d have been on the phone with client service immediately they did also handled to miss out on drilling the pilot holes where you can connect the control box to the desktop a great deal of having to do that myself without accidentally drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be connecting the surface to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from having to drill that top was in fact pretty simple the whole thing came together in about 45 minutes and despite the fact that there’s cable televisions going to it from each component to support motorized function unusually absolutely where any type of cable management materials whatsoever the frame on this system is a single motor dual phase design versus the dual motor three-stage design that comes standard with the uplift desk this can be upgraded also to both the double phase dual motor and a three-stage dual motor which presses the expense of the desk up

an additional 70 bucks the frame is developed for a max load of 154 pounds and it moves at a rate at an inch per second the height can range from simply under 28 inches to just over forty seven point 6 inches so a max I ‘d it is more than tall adequate even for me and I stay at 6 foot for this model does come basic with the control board that allows for up-and-down movement plus three memory spots with an LED readout to inform you the desk height the single motor design utilizes this drive shaft assembly which has to be adjusted as the width of the desk is changed the motor operation itself while it might be slow is very peaceful as in barely audible this outside a cost would be the one benefit I would offer this unit over the uplift desk and I wish to be careful here because this isn’t a hit piece this desk is 240 dollars cheaper than the comparable uplift model over 35% more affordable even if you upgrade this flexi spot test to the dual motor three-stage design it still is available in a hundred and seventy dollars less expensive than the uplift however cheaper does not imply low-cost this desk is still over four hundred dollars if I had actually paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is solid even if max height I’ll definitely offer it that but the lateral stability of this desk the horizontal movement at this rate point it’s undesirable it’s add fuel to the fire here they consist of a little safety baffle this little steel piece that mounts to the frame and covers a portion of this rotating driveshaft when

this desk sees any lateral movement at all the drive shaft hits this baffle and the sound is absolutely shocking to top things off I decided to add rolling casters to this desk this was a $30 upgrade and 2 of those four casters got here harmed also my plan for this desk at this point is to lose the desk top and included completely and change it with a white laminate lemon table from Ikea and utilize it as an adjustable picture table which you can’t do this frame will accommodate desktops approximately 63 inches broad and 31 and a half inches deep so this will roll around the studio make it simpler to film products without having to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift initially that is a financial investment in quality workplace furniture that will last you this at finest feels like a more affordable imitation of that it simply does not feel quality and the difference between this desk and my main desk is night and day do do not hesitate to take a look at their site too which also feels eerily similar to one of their rivals there’s a wealth of devices you can get for the flexi spot desk up to and consisting of a foot massager and even a stationary exercise bike and I might spend another 10 minutes of our precious time covering numerous alternatives and accessories I might but I think I’m happier that they only sent a fundamental desk due to the fact that as a fundamental desk I’m not a fan of the quality control at this rate point and I don’t think slapping on a bunch of extras is the relocation when the core product isn’t what it must be they do provide a 30-day trial if you’re simply morbidly curious and they service warranty their desks for 3 years really desk is five years and uplift desk is 7 years if you are Flexispot Standing Desk Gaming

in the market for a sit-stand desk they’re fantastic mine’s been a life changer for me both in regards to gaming and performance however I would invest the additional money it’s gon na take to enter into a greater end producer like uplift desk or extremely desk and I haven’t personally utilized really desk products so I can’t speak on it however their credibility is excellent huge thanks to flexi area for sending this out for evaluation unfortunately I can not suggest this unit and for the record I’m a hundred percent sure they would have happily changed the parts that I had a concern with seeing as how both the desktop and the casters showed up damaged however from a customer perspective you ‘d probably be really delighted to get this in