Flexispot Standing Desk Evaluation …Flexispot Pc Mount…
Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are minimal, here are a few features that I wasn’t always a big fan of:
The bundle that the desk came in was heavy, so bringing it inside was a group effort, but this is simply an effect of how tough the Flexispot is.
The convenient cable tray was a little bit confusing to set up. In the end, you ultimately slip it under screws, which wasn’t really clear from the guidelines.
You will need to purchase an anti-fatigue mat to remain comfy, but this is a good idea for any standing desks, so I can’t fault Flexispot for that.
When it arrived and I saw how heavy it was, I was both thrilled (since this indicated it was going to be tough) and also a little reluctant (since all of us know how much of a difficulty assembling furniture can be).
Luckily, with the help of a training YouTube link, it took me just around 42 minutes to assemble. Scratch that, it took my 11-year-old child, with some guidance from me, from start to finish. The only problem I have with assembly was the cable tray, which I found wasn’t explained well in the guidelines.
Once put together, I like the smooth look of this desk. I’m confident any of the many diverse finishes that it comes in would look fantastic in any office, and the adjustable width makes it simple to fit it in even the tiniest of office.
The quiet operation and height memory settings make it easy, efficient, and peaceful to change between sitting and standing as often times as you desire throughout the day.
Finally, this desk is tough. It can hold up to 335 lbs even while in operation, so if you have a hefty desktop (or wish to rest on it for some reason) it has you covered. It will also equally disperse weight no matter how out of balance the weight you put on it is, it won’t wiggle or wobble.
because video is pretty kitted out as the desk we’re taking a look at today is quite standard I tried to get as near to that as I might on uplifts website with equivalent configurations the flexi spot desk we’re looking at today will run you about four hundred and ten dollars versus 6 hundred and fifty for a similar desk from uplift I try to get as close as possible with the uplift model is actually 5 inches longer however you can do a lot with five inches boom yes now for openness flexi area did send this desk out for evaluation but as you should know by now doesn’t affect my evaluation in any way the desktop here is 55 inches wide 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming however it’s not shipping up until the end of April at the earliest the desktop is an inch thick but it’s this standard laminate as you can perhaps get doing not have even any cable television grommets for travel through the outside container
for the desktop was not damaged in any way which is utterly strange since I could shoot a 30-second b-roll montage of just the damage and defects on this desktop scuffed scraped pitted just super rough guy if I had bought this I ‘d have been on the phone with client service right away they did also handled to miss out on drilling the pilot holes where you can connect the control box to the desktop a great deal of having to do that myself without mistakenly drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be connecting the surface to the frame that’s a far cry from the embedded metal inserts that we saw on the uplift desk so assembly aside from having to drill that top was really pretty straightforward the entire thing came together in about 45 minutes and despite the fact that there’s cables going to it from each part to support motorized function unusually definitely where any sort of cable management materials whatsoever the frame on this unit is a single motor dual stage style versus the double motor three-stage design that comes requirement with the uplift desk this can be updated as well to both the dual phase dual motor and a three-stage dual motor which pushes the cost of the desk up
an extra 70 bucks the frame is developed for a max load of 154 pounds and it moves at a rate at an inch per second the height can vary from simply under 28 inches to simply over forty 7 point 6 inches so a max I ‘d it is more than tall enough even for me and I stay at 6 foot for this model does come standard with the control board that permits up-and-down motion plus 3 memory spots with an LED readout to tell you the desk height the single motor style uses this drive shaft assembly which has to be adjusted as the width of the desk is changed the motor operation itself while it might be slow is extremely quiet as in barely audible this outside a cost would be the one benefit I would provide this unit over the uplift desk and I wish to be careful here due to the fact that this isn’t a hit piece this desk is 240 dollars less expensive than the comparable uplift design over 35% less expensive even if you upgrade this flexi area test to the double motor three-stage style it still is available in a hundred and seventy dollars less expensive than the uplift however less expensive does not mean cheap this desk is still over four hundred dollars if I had actually paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is strong even if max height I’ll absolutely give it that but the lateral stability of this desk the horizontal movement at this cost point it’s unacceptable it’s add fuel to the fire here they include a little security baffle this little steel piece that installs to the frame and covers a portion of this turning driveshaft when
this desk sees any lateral motion at all the drive shaft strikes this baffle and the noise is definitely infuriating to top things off I decided to add rolling casters to this desk this was a $30 upgrade and two of those four casters arrived damaged too my prepare for this desk at this point is to lose the desk top and came with completely and replace it with a white laminate lemon table from Ikea and utilize it as an adjustable photo table which you can’t do this frame will accommodate desktops up to 63 inches large and 31 and a half inches deep so this will roll around the studio make it simpler to movie items without needing to adjust complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I found uplift first that is an investment in quality office furnishings that will last you this at best feels like a less expensive replica of that it just does not feel quality and the distinction between this desk and my primary desk is night and day do do not hesitate to take a look at their website also which also feels strangely similar to among their rivals there’s a wealth of devices you can get for the flexi area desk up to and including a foot massager and even a stationary exercise bike and I might spend another 10 minutes of our valuable time covering numerous options and devices I could but I believe I’m better that they only sent a basic desk due to the fact that as a fundamental desk I’m not a fan of the quality control at this price point and I don’t think slapping on a bunch of extras is the move when the core item isn’t what it ought to be they do use a 30-day trial if you’re just morbidly curious and they guarantee their desks for 3 years extremely desk is five years and uplift desk is 7 years if you are Flexispot Pc Mount
in the market for a sit-stand desk they’re remarkable mine’s been a life changer for me both in regards to video gaming and performance however I would invest the additional money it’s gon na take to enter a greater end manufacturer like uplift desk or extremely desk and I haven’t personally utilized really desk products so I can’t speak on it however their credibility is excellent huge thanks to flexi spot for sending this out for review sadly I can not advise this unit and for the record I’m a hundred percent sure they would have gladly changed the parts that I had an issue with viewing as how both the desktop and the casters got here harmed however from a consumer standpoint you ‘d most likely be really delighted to get this in