Flexispot Office Desk – 77% OFF Today Only

Flexispot Standing Desk Review …Flexispot Office Desk…

Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are very little, here are a couple of features that I wasn’t always a substantial fan of:

The plan that the desk can be found in was heavy, so bringing it inside was a group effort, however this is simply an effect of how sturdy the Flexispot is.
The hassle-free cable tray was a bit confusing to set up. In the end, you ultimately slip it under screws, which wasn’t really clear from the directions.
You will need to purchase an anti-fatigue mat to stay comfy, however this is an excellent idea for any standing desks, so I can’t fault Flexispot for that.

When it arrived and I saw how heavy it was, I was both ecstatic (since this implied it was going to be tough) and also a little hesitant (since all of us know just how much of a difficulty putting together furnishings can be).

Luckily, with the help of a training YouTube link, it took me only around 42 minutes to put together. Scratch that, it took my 11-year-old child, with some supervision from me, from start to finish. The only problem I have with assembly was the cable tray, which I found wasn’t explained well in the directions.

Once assembled, I love the sleek look of this desk. I’m positive any of the many diverse finishes that it comes in would look fantastic in any office, and the adjustable width makes it simple to fit it in even the tiniest of office.

The quiet operation and height memory settings make it simple, effective, and quiet to change in between sitting and standing as sometimes as you want throughout the day.

Lastly, this desk is sturdy. It can hold up to 335 lbs even while in operation, so if you have a large desktop computer (or want to sleep on it for some reason) it has you covered. It will likewise uniformly distribute weight no matter how out of balance the weight you place on it is, it will not wobble or wiggle.

 

because video is quite kitted out as the desk we’re taking a look at today is quite fundamental I attempted to get as near that as I might on uplifts website with equivalent configurations the flexi area desk we’re taking a look at today will run you about four hundred and 10 dollars versus six hundred and fifty for a similar desk from uplift I attempt to get as close as possible with the uplift model is really five inches longer however you can do a lot with 5 inches boom yes now for transparency flexi area did send this desk out for review but as you need to understand by now doesn’t impact my review in any way the desktop here is 55 inches broad 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not shipping till completion of April at the earliest the desktop is an inch thick however it’s this fundamental laminate as you can potentially get doing not have even any cable television grommets for go through the outside container

for the desktop was not harmed in any way which is absolutely strange because I might shoot a 30-second b-roll montage of just the damage and defects on this desktop scuffed scraped pitted simply extremely rough guy if I had actually purchased this I ‘d have been on the phone with customer support immediately they did also managed to miss drilling the pilot holes where you can connect the control box to the desktop a lot of needing to do that myself without inadvertently drilling through the opposite of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface area to the frame that’s a far cry from the embedded metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was in fact pretty uncomplicated the entire thing came together in about 45 minutes and despite the fact that there’s cable televisions running to it from each element to support motorized function unusually absolutely where any sort of cable television management products whatsoever the frame on this system is a single motor dual stage design versus the double motor three-stage design that comes requirement with the uplift desk this can be updated as well to both the double phase double motor and a three-stage dual motor which presses the cost of the desk up

an additional 70 bucks the frame is designed for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can range from simply under 28 inches to just over forty seven point 6 inches so a max I ‘d it is more than high adequate even for me and I remain at 6 foot for this design does come basic with the control board that permits up-and-down motion plus 3 memory areas with an LED readout to tell you the desk height the single motor style uses this drive shaft assembly which has to be adjusted as the width of the desk is changed the motor operation itself while it might be slow is really peaceful as in barely audible this outside a cost would be the one benefit I would provide this unit over the uplift desk and I want to take care here due to the fact that this isn’t a hit piece this desk is 240 dollars more affordable than the equivalent uplift design over 35% cheaper even if you upgrade this flexi area test to the dual motor three-stage design it still can be found in a hundred and seventy dollars cheaper than the uplift but more affordable doesn’t imply low-cost this desk is still over four hundred dollars if I had actually paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is strong even if max height I’ll absolutely offer it that but the lateral stability of this desk the horizontal movement at this rate point it’s undesirable it’s add fuel to the fire here they include a little safety baffle this little steel piece that mounts to the frame and covers a part of this rotating driveshaft when

this desk sees any lateral movement at all the drive shaft strikes this baffle and the sound is absolutely infuriating to top things off I chose to add rolling casters to this desk this was a $30 upgrade and two of those 4 casters got here harmed also my prepare for this desk at this point is to lose the desk top and included entirely and replace it with a white laminate lemon table from Ikea and utilize it as an adjustable picture table which you can’t do this frame will accommodate desktops approximately 63 inches large and 31 and a half inches deep so this will roll around the studio make it easier to movie items without having to adjust complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift initially that is a financial investment in quality workplace furniture that will last you this at finest feels like a less expensive replica of that it just does not feel quality and the distinction between this desk and my primary desk is night and day do feel free to take a look at their website also which also feels eerily comparable to among their competitors there’s a wealth of accessories you can get for the flexi area desk up to and including a foot massager and even a fixed exercise bike and I might invest another 10 minutes of our valuable time covering different choices and devices I might but I believe I’m better that they only sent a fundamental desk due to the fact that as a fundamental desk I’m not a fan of the quality assurance at this price point and I do not think slapping on a lot of bonus is the move when the core item isn’t what it ought to be they do offer a 30-day trial if you’re simply morbidly curious and they service warranty their desks for 3 years really desk is five years and uplift desk is 7 years if you are Flexispot Office Desk

in the market for a sit-stand desk they’re fantastic mine’s been a life changer for me both in regards to gaming and efficiency but I would spend the additional money it’s gon na take to enter into a greater end manufacturer like uplift desk or very desk and I haven’t personally used really desk products so I can’t speak on it but their credibility is very good big thanks to flexi area for sending this out for review unfortunately I can not recommend this unit and for the record I’m a hundred percent sure they would have happily replaced the parts that I had a problem with seeing as how both the desktop and the casters arrived damaged but from a consumer viewpoint you ‘d most likely be really delighted to get this in