Flexispot Standing Desk Evaluation …Flexispot Motor…
Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are very little, here are a few features that I wasn’t necessarily a big fan of:
The bundle that the desk can be found in was heavy, so bringing it inside was a group effort, but this is simply an effect of how sturdy the Flexispot is.
The hassle-free cable television tray was a little bit confusing to set up. In the end, you eventually slip it under screws, which wasn’t very clear from the directions.
You will require to buy an anti-fatigue mat to remain comfortable, however this is a good idea for any standing desks, so I can’t fault Flexispot for that.
When it arrived and I saw how heavy it was, I was both excited (because this meant it was going to be tough) and also a little reluctant (because all of us understand just how much of an obstacle assembling furnishings can be).
Thankfully, with the help of a training YouTube link, it took me only around 42 minutes to put together. Scratch that, it took my 11-year-old daughter, with some guidance from me, from start to finish. The only problem I have with assembly was the cable television tray, which I found wasn’t described well in the instructions.
Once put together, I love the smooth look of this desk. I’m positive any of the many varied finishes that it comes in would look excellent in any office, and the adjustable width makes it simple to fit it in even the smallest of home offices.
The peaceful operation and height memory settings make it easy, effective, and peaceful to switch between sitting and standing as many times as you desire throughout the day.
This desk is durable. It can hold up to 335 lbs even while in operation, so if you have a hefty desktop (or wish to take a nap on it for some reason) it has you covered. It will likewise uniformly distribute weight no matter how out of balance the weight you place on it is, it will not wobble or wiggle.
because video is quite kitted out as the desk we’re taking a look at today is pretty basic I tried to get as near to that as I could on uplifts site with equivalent configurations the flexi spot desk we’re looking at today will run you about four hundred and 10 dollars versus 6 hundred and fifty for a similar desk from uplift I attempt to get as close as possible with the uplift design is in fact five inches longer but you can do a lot with five inches boom yes now for openness flexi spot did send this desk out for review however as you must understand by now doesn’t affect my evaluation in any way the desktop here is 55 inches broad 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not delivering until completion of April at the earliest the desktop is an inch thick however it’s this standard laminate as you can potentially get lacking even any cable television grommets for travel through the outside carton
for the desktop was not damaged in any way which is absolutely unusual because I could shoot a 30-second b-roll montage of simply the damage and defects on this desktop scuffed scraped pitted simply super rough male if I had actually purchased this I ‘d have been on the phone with customer service right away they did also managed to miss drilling the pilot holes where you can attach the control box to the desktop a lot of having to do that myself without accidentally drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface to the frame that’s a far cry from the embedded metal inserts that we saw on the uplift desk so assembly aside from having to drill that top was really pretty simple the entire thing came together in about 45 minutes and despite the fact that there’s cables going to it from each element to support motorized function oddly absolutely where any sort of cable television management products whatsoever the frame on this system is a single motor dual phase style versus the double motor three-stage style that comes requirement with the uplift desk this can be upgraded too to both the double phase double motor and a three-stage dual motor which presses the expense of the desk up
an extra 70 dollars the frame is created for a max load of 154 pounds and it moves at a rate at an inch per second the height can vary from simply under 28 inches to just over forty seven point 6 inches so a max I ‘d it is more than tall sufficient even for me and I stay at 6 foot for this model does come standard with the control board that permits up-and-down movement plus 3 memory areas with an LED readout to inform you the desk height the single motor style uses this drive shaft assembly which has to be adjusted as the width of the desk is adjusted the motor operation itself while it might be slow is extremely quiet as in barely audible this outside a price would be the one advantage I would give this unit over the uplift desk and I wish to beware here because this isn’t a hit piece this desk is 240 dollars less expensive than the equivalent uplift design over 35% more affordable even if you update this flexi area test to the double motor three-stage style it still is available in a hundred and seventy dollars more affordable than the uplift but more affordable does not indicate low-cost this desk is still over four hundred dollars if I had actually paid over $400 for this desk I ‘d have an issue with that the front to back stability of this desk is solid even if max height I’ll certainly provide it that but the lateral stability of this desk the horizontal motion at this price point it’s inappropriate it’s add insult to injury here they consist of a little security baffle this little steel piece that mounts to the frame and covers a portion of this rotating driveshaft when
this desk sees any lateral movement at all the drive shaft strikes the sound and this baffle is definitely shocking to leading things off I chose to add rolling casters to this desk this was a $30 upgrade and two of those four casters showed up damaged too my plan for this desk at this moment is to lose the desk top and came with all together and change it with a white laminate lemon table from Ikea and use it as an adjustable image table which you can’t do this frame will accommodate desktops up to 63 inches large and 31 and a half inches deep so this will roll around the studio make it simpler to movie products without having to adjust complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift initially that is a financial investment in quality workplace furniture that will last you this at best feels like a less expensive replica of that it just doesn’t feel quality and the distinction between this desk and my primary desk is night and day do do not hesitate to check out their website too which also feels strangely comparable to one of their competitors there’s a wealth of accessories you can get for the flexi spot desk approximately and including a foot massager and even a stationary exercise bike and I might invest another 10 minutes of our valuable time covering numerous alternatives and accessories I could but I think I’m better that they just sent a basic desk due to the fact that as a standard desk I’m not a fan of the quality control at this cost point and I don’t believe slapping on a bunch of additionals is the move when the core product isn’t what it must be they do use a 30-day trial if you’re simply morbidly curious and they guarantee their desks for 3 years extremely desk is five years and uplift desk is seven years if you are Flexispot Motor
in the market for a sit-stand desk they’re amazing mine’s been a life changer for me both in regards to gaming and performance but I would invest the money it’s gon na take to enter a higher end manufacturer like uplift desk or extremely desk and I have not personally utilized very desk products so I can’t speak on it however their credibility is very good huge thanks to flexi spot for sending this out for review unfortunately I can not suggest this system and for the record I’m a hundred percent sure they would have gladly changed the parts that I had a problem with seeing as how both the desktop and the casters got here damaged however from a consumer perspective you ‘d most likely be really excited to get this in