Flexispot M2 – 77% OFF Today Only

Flexispot Standing Desk Review …Flexispot M2…

Cons: What I Didn’t Like About the Flexispot E7
Though the cons on this desk are very little, here are a few features that I wasn’t necessarily a huge fan of:

The plan that the desk can be found in was heavy, so bringing it inside was a group effort, but this is simply a consequence of how durable the Flexispot is.
The practical cable television tray was a bit complicated to set up. In the end, you ultimately slip it under screws, which wasn’t really clear from the directions.
You will need to buy an anti-fatigue mat to stay comfortable, however this is an excellent concept for any standing desks, so I can’t fault Flexispot for that.

When it showed up and I saw how heavy it was, I was both thrilled (because this indicated it was going to be tough) and also a little reluctant (since we all know just how much of a challenge assembling furniture can be).

Thankfully, with the help of an instructional YouTube link, it took me just around 42 minutes to put together. Scratch that, it took my 11-year-old daughter, with some supervision from me, from start to finish. The only hang-up I have with assembly was the cable television tray, which I discovered wasn’t explained well in the instructions.

Once put together, I enjoy the smooth look of this desk. I’m positive any of the many varied surfaces that it comes in would look fantastic in any workplace, and the adjustable width makes it easy to fit it in even the smallest of home offices.

The quiet operation and height memory settings make it simple, effective, and peaceful to change in between sitting and standing as sometimes as you want throughout the day.

This desk is strong. It can hold up to 335 lbs even while in operation, so if you have a significant desktop (or wish to rest on it for some reason) it has you covered. It will likewise equally distribute weight no matter how out of balance the weight you put on it is, it won’t wobble or wiggle.

 

because video is quite kitted out as the desk we’re looking at today is quite fundamental I tried to get as close to that as I might on uplifts site with equivalent setups the flexi spot desk we’re looking at today will run you about four hundred and ten dollars versus six hundred and fifty for a comparable desk from uplift I attempt to get as close as possible with the uplift design is in fact five inches longer but you can do a lot with 5 inches boom yes now for openness flexi area did send this desk out for review however as you ought to understand by now does not impact my evaluation in any way the desktop here is 55 inches broad 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming however it’s not delivering until the end of April at the earliest the desktop is an inch thick however it’s this basic laminate as you can possibly get lacking even any cable television grommets for go through the outside container

for the desktop was not damaged in any way which is entirely unusual due to the fact that I could shoot a 30-second b-roll montage of simply the damage and flaws on this desktop scuffed scraped pitted just extremely rough male if I had acquired this I ‘d have been on the phone with customer care right away they did also managed to miss drilling the pilot holes where you can attach the control box to the desktop a great deal of needing to do that myself without accidentally drilling through the opposite of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface area to the frame that’s a far cry from the embedded metal inserts that we saw on the uplift desk so assembly aside from having to drill that top was really pretty simple the whole thing came together in about 45 minutes and despite the fact that there’s cables running to it from each part to support motorized function strangely absolutely where any sort of cable television management materials whatsoever the frame on this system is a single motor dual phase style versus the dual motor three-stage style that comes standard with the uplift desk this can be upgraded as well to both the dual stage double motor and a three-stage dual motor which presses the expense of the desk up

an extra 70 dollars the frame is designed for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can vary from simply under 28 inches to simply over forty seven point 6 inches so a max I ‘d it is more than tall adequate even for me and I stay at 6 foot for this model does come basic with the control board that permits up-and-down motion plus 3 memory areas with an LED readout to inform you the desk height the single motor style utilizes this drive shaft assembly which needs to be changed as the width of the desk is adjusted the motor operation itself while it might be sluggish is really quiet as in barely audible this outside a cost would be the one advantage I would provide this unit over the uplift desk and I wish to be careful here since this isn’t a hit piece this desk is 240 dollars cheaper than the similar uplift design over 35% cheaper even if you upgrade this flexi spot test to the double motor three-stage design it still is available in a hundred and seventy dollars more affordable than the uplift however less expensive doesn’t indicate inexpensive this desk is still over four hundred dollars if I had actually paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is strong even if max height I’ll definitely provide it that however the lateral stability of this desk the horizontal movement at this rate point it’s unacceptable it’s rub salt in the wound here they consist of a little safety baffle this little steel piece that mounts to the frame and covers a part of this turning driveshaft when

this desk sees any lateral motion at all the drive shaft strikes this baffle and the sound is absolutely frustrating to leading things off I chose to include rolling casters to this desk this was a $30 upgrade and 2 of those four casters arrived damaged also my prepare for this desk at this point is to lose the desk top and featured all together and replace it with a white laminate lemon table from Ikea and use it as an adjustable image table which you can’t do this frame will accommodate desktops up to 63 inches large and 31 and a half inches deep so this will roll around the studio make it easier to film items without having to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift initially that is an investment in quality workplace furnishings that will last you this at finest seems like a more affordable imitation of that it simply doesn’t feel quality and the difference between this desk and my main desk is night and day do feel free to have a look at their site as well which likewise feels eerily comparable to among their competitors there’s a wealth of accessories you can get for the flexi area desk approximately and including a foot massager and even a fixed exercise bike and I could spend another 10 minutes of our valuable time covering numerous alternatives and accessories I might however I believe I’m happier that they only sent a basic desk due to the fact that as a fundamental desk I’m not a fan of the quality assurance at this rate point and I do not believe slapping on a lot of additionals is the move when the core product isn’t what it ought to be they do offer a 30-day trial if you’re simply morbidly curious and they service warranty their desks for 3 years extremely desk is 5 years and uplift desk is 7 years if you are Flexispot M2

in the market for a sit-stand desk they’re remarkable mine’s been a life changer for me both in regards to gaming and performance but I would spend the additional money it’s gon na take to enter into a higher end producer like uplift desk or extremely desk and I haven’t personally used really desk products so I can’t speak on it however their credibility is excellent big thanks to flexi spot for sending this out for review regrettably I can not advise this unit and for the record I’m a hundred percent sure they would have gladly replaced the parts that I had a concern with viewing as how both the desktop and the casters showed up damaged but from a customer standpoint you ‘d probably be actually delighted to get this in