Flexispot Kana – 77% OFF Today Only

Flexispot Standing Desk Review …Flexispot Kana…

Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are minimal, here are a couple of features that I wasn’t always a big fan of:

The package that the desk can be found in was heavy, so bringing it inside was a group effort, however this is just a consequence of how strong the Flexispot is.
The hassle-free cable television tray was a little bit confusing to set up. In the end, you eventually slip it under screws, which wasn’t extremely clear from the directions.
You will need to buy an anti-fatigue mat to stay comfy, but this is an excellent concept for any standing desks, so I can’t fault Flexispot for that.

When it arrived and I saw how heavy it was, I was both fired up (since this suggested it was going to be tough) and likewise a little reluctant (because all of us understand just how much of a challenge putting together furnishings can be).

Fortunately, with the help of a training YouTube link, it took me only around 42 minutes to put together. Scratch that, it took my 11-year-old daughter, with some supervision from me, from start to finish. The only problem I have with assembly was the cable television tray, which I found wasn’t explained well in the directions.

When assembled, I like the sleek appearance of this desk. I’m confident any of the many varied finishes that it comes in would look great in any workplace, and the adjustable width makes it easy to fit it in even the smallest of office.

The peaceful operation and height memory settings make it easy, efficient, and peaceful to switch between sitting and standing as often times as you want throughout the day.

Last but not least, this desk is sturdy. It can hold up to 335 pounds even while in operation, so if you have a large desktop (or wish to rest on it for some reason) it has you covered. It will also evenly distribute weight no matter how out of balance the weight you put on it is, it won’t wiggle or wobble.

 

in that video is quite kitted out as the desk we’re looking at today is pretty standard I tried to get as close to that as I might on uplifts website with similar setups the flexi area desk we’re taking a look at today will run you about four hundred and ten dollars versus 6 hundred and fifty for a comparable desk from uplift I attempt to get as close as possible with the uplift design is in fact five inches longer but you can do a lot with 5 inches boom yes now for transparency flexi area did send this desk out for evaluation however as you should understand by now does not affect my evaluation in any way the desktop here is 55 inches wide 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not shipping until completion of April at the earliest the desktop is an inch thick however it’s this basic laminate as you can possibly get doing not have even any cable television grommets for pass through the outside carton

for the desktop was not damaged in any way which is entirely bizarre since I might shoot a 30-second b-roll montage of just the damage and defects on this desktop scuffed scraped pitted just extremely rough male if I had actually bought this I ‘d have been on the phone with customer care right away they did likewise managed to miss out on drilling the pilot holes where you can connect the control box to the desktop a lot of needing to do that myself without accidentally drilling through the opposite of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from having to drill that top was really quite uncomplicated the entire thing came together in about 45 minutes and despite the fact that there’s cable televisions running to it from each part to support motorized function unusually absolutely where any sort of cable management materials whatsoever the frame on this unit is a single motor double stage style versus the dual motor three-stage design that comes requirement with the uplift desk this can be upgraded too to both the double phase double motor and a three-stage dual motor which pushes the cost of the desk up

an extra 70 bucks the frame is created for a max load of 154 pounds and it moves at a rate at an inch per second the height can range from simply under 28 inches to simply over forty 7 point 6 inches so a max I ‘d it is more than tall sufficient even for me and I remain at 6 foot for this model does come standard with the control panel that permits up-and-down motion plus 3 memory spots with an LED readout to tell you the desk height the single motor style utilizes this drive shaft assembly which needs to be changed as the width of the desk is adjusted the motor operation itself while it might be slow is really peaceful as in barely audible this outside a rate would be the one advantage I would give this unit over the uplift desk and I wish to be careful here due to the fact that this isn’t a hit piece this desk is 240 dollars cheaper than the comparable uplift model over 35% more affordable even if you upgrade this flexi area test to the double motor three-stage design it still can be found in a hundred and seventy dollars cheaper than the uplift however more affordable does not imply cheap this desk is still over four hundred dollars if I had paid over $400 for this desk I ‘d have an issue with that the front to back stability of this desk is strong even if max height I’ll absolutely provide it that however the lateral stability of this desk the horizontal movement at this cost point it’s unacceptable it’s add fuel to the fire here they consist of a little security baffle this little steel piece that mounts to the frame and covers a part of this rotating driveshaft when

this desk sees any lateral movement at all the drive shaft strikes the noise and this baffle is absolutely infuriating to top things off I decided to add rolling casters to this desk this was a $30 upgrade and two of those 4 casters got here damaged too my plan for this desk at this moment is to lose the desk top and featured entirely and change it with a white laminate lemon table from Ikea and use it as an adjustable photo table which you can’t do this frame will accommodate desktops up to 63 inches broad and 31 and a half inches deep so this will roll around the studio make it easier to movie products without needing to adjust complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift first that is an investment in quality office furnishings that will last you this at best seems like a more affordable imitation of that it simply doesn’t feel quality and the difference between this desk and my main desk is night and day do feel free to take a look at their website as well which also feels strangely comparable to among their rivals there’s a wealth of accessories you can get for the flexi spot desk up to and consisting of a foot massager and even a fixed exercise bike and I might invest another 10 minutes of our precious time covering various alternatives and devices I could however I think I’m better that they just sent out a fundamental desk due to the fact that as a basic desk I’m not a fan of the quality assurance at this rate point and I don’t believe slapping on a bunch of bonus is the relocation when the core product isn’t what it ought to be they do offer a 30-day trial if you’re just morbidly curious and they guarantee their desks for 3 years really desk is 5 years and uplift desk is 7 years if you are Flexispot Kana

in the market for a sit-stand desk they’re remarkable mine’s been a life changer for me both in terms of gaming and efficiency however I would invest the additional money it’s gon na take to enter a higher end maker like uplift desk or very desk and I have not personally utilized really desk items so I can’t speak on it but their credibility is very good huge thanks to flexi area for sending this out for evaluation regrettably I can not recommend this unit and for the record I’m a hundred percent sure they would have gladly changed the parts that I had an issue with seeing as how both the desktop and the casters showed up harmed however from a consumer viewpoint you ‘d most likely be really thrilled to get this in