Flexispot Height Adjustable Desk – 77% OFF Today Only

Flexispot Standing Desk Review …Flexispot Height Adjustable Desk…

Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are minimal, here are a couple of functions that I wasn’t always a big fan of:

The plan that the desk can be found in was heavy, so bringing it inside was a group effort, however this is just a consequence of how sturdy the Flexispot is.
The hassle-free cable television tray was a little bit complicated to set up. In the end, you eventually slip it under screws, which wasn’t extremely clear from the instructions.
You will need to buy an anti-fatigue mat to remain comfy, however this is an excellent idea for any standing desks, so I can’t fault Flexispot for that.

When it showed up and I saw how heavy it was, I was both ecstatic (since this suggested it was going to be sturdy) and also a little hesitant (because we all understand just how much of a difficulty assembling furnishings can be).

The good news is, with the help of an instructional YouTube link, it took me just around 42 minutes to assemble. Scratch that, it took my 11-year-old daughter, with some supervision from me, from start to finish. The only hang-up I have with assembly was the cable tray, which I discovered wasn’t discussed well in the guidelines.

Once assembled, I love the smooth appearance of this desk. I’m confident any of the many diverse finishes that it comes in would look great in any workplace, and the adjustable width makes it easy to fit it in even the smallest of office.

The peaceful operation and height memory settings make it easy, efficient, and peaceful to change in between sitting and standing as many times as you want throughout the day.

This desk is tough. It can hold up to 335 pounds even while in operation, so if you have a large desktop (or want to rest on it for some reason) it has you covered. It will also equally distribute weight no matter how unbalanced the weight you place on it is, it won’t wobble or wiggle.

 

because video is quite kitted out as the desk we’re taking a look at today is pretty basic I tried to get as near that as I could on uplifts site with similar setups the flexi spot desk we’re looking at today will run you about four hundred and 10 dollars versus 6 hundred and fifty for a similar desk from uplift I try to get as close as possible with the uplift design is actually five inches longer however you can do a lot with 5 inches boom yes now for openness flexi spot did send this desk out for evaluation however as you ought to understand by now doesn’t affect my review in any way the desktop here is 55 inches wide 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not delivering up until completion of April at the earliest the desktop is an inch thick but it’s this basic laminate as you can possibly get doing not have even any cable television grommets for pass through the outside carton

for the desktop was not harmed in any way which is entirely unusual due to the fact that I could shoot a 30-second b-roll montage of just the damage and defects on this desktop scuffed scraped pitted simply extremely rough guy if I had actually bought this I ‘d have been on the phone with customer service instantly they did also handled to miss drilling the pilot holes where you can connect the control box to the desktop a lot of having to do that myself without inadvertently drilling through the opposite of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was actually quite straightforward the entire thing came together in about 45 minutes and despite the fact that there’s cables running to it from each element to support motorized function unusually absolutely where any sort of cable television management materials whatsoever the frame on this system is a single motor dual phase design versus the dual motor three-stage design that comes requirement with the uplift desk this can be upgraded as well to both the double stage double motor and a three-stage double motor which pushes the cost of the desk up

an extra 70 bucks the frame is developed for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can range from just under 28 inches to just over forty seven point six inches so a max I ‘d it is more than tall enough even for me and I stay at 6 foot for this model does come standard with the control panel that allows for up-and-down motion plus three memory spots with an LED readout to tell you the desk height the single motor style uses this drive shaft assembly which has to be adjusted as the width of the desk is changed the motor operation itself while it might be slow is very quiet as in barely audible this outside a rate would be the one benefit I would offer this unit over the uplift desk and I wish to be careful here due to the fact that this isn’t a hit piece this desk is 240 dollars cheaper than the equivalent uplift design over 35% less expensive even if you upgrade this flexi spot test to the dual motor three-stage design it still can be found in a hundred and seventy dollars less expensive than the uplift however more affordable doesn’t imply low-cost this desk is still over four hundred dollars if I had paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is solid even if max height I’ll absolutely offer it that but the lateral stability of this desk the horizontal motion at this cost point it’s undesirable it’s rub salt in the wound here they consist of a little safety baffle this little steel piece that installs to the frame and covers a portion of this turning driveshaft when

this desk sees any lateral movement at all the drive shaft strikes this baffle and the noise is absolutely infuriating to top things off I chose to add rolling casters to this desk this was a $30 upgrade and two of those 4 casters arrived harmed too my prepare for this desk at this point is to lose the desk top and included completely and replace it with a white laminate lemon table from Ikea and use it as an adjustable picture table which you can’t do this frame will accommodate desktops as much as 63 inches broad and 31 and a half inches deep so this will roll around the studio make it simpler to movie products without having to adjust complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift initially that is an investment in quality office furnishings that will last you this at finest feels like a cheaper imitation of that it simply does not feel quality and the difference between this desk and my main desk is night and day do do not hesitate to check out their site too which likewise feels strangely similar to among their competitors there’s a wealth of devices you can get for the flexi spot desk approximately and including a foot massager and even a fixed stationary bicycle and I might spend another 10 minutes of our valuable time covering various options and devices I might but I think I’m happier that they just sent a standard desk because as a fundamental desk I’m not a fan of the quality assurance at this rate point and I do not think slapping on a bunch of bonus is the relocation when the core item isn’t what it should be they do provide a 30-day trial if you’re simply morbidly curious and they guarantee their desks for three years really desk is five years and uplift desk is 7 years if you are Flexispot Height Adjustable Desk

in the market for a sit-stand desk they’re incredible mine’s been a life changer for me both in terms of video gaming and performance but I would invest the extra money it’s gon na take to enter into a higher end maker like uplift desk or extremely desk and I have not personally used extremely desk products so I can’t speak on it however their track record is very good huge thanks to flexi spot for sending this out for evaluation unfortunately I can not recommend this system and for the record I’m a hundred percent sure they would have happily replaced the parts that I had a concern with seeing as how both the desktop and the casters showed up damaged but from a customer standpoint you ‘d most likely be truly delighted to get this in