Flexispot E8 Test – 77% OFF Today Only

Flexispot Standing Desk Review …Flexispot E8 Test…

Cons: What I Didn’t Like About the Flexispot E7
Though the cons on this desk are minimal, here are a couple of features that I wasn’t necessarily a substantial fan of:

The package that the desk came in was heavy, so bringing it inside was a group effort, however this is simply an effect of how tough the Flexispot is.
The convenient cable tray was a bit complicated to install. In the end, you eventually slip it under screws, which wasn’t extremely clear from the guidelines.
You will need to buy an anti-fatigue mat to stay comfy, however this is a great idea for any standing desks, so I can’t fault Flexispot for that.

When it showed up and I saw how heavy it was, I was both excited (given that this suggested it was going to be strong) and likewise a little hesitant (because we all understand just how much of an obstacle assembling furnishings can be).

The good news is, with the help of an educational YouTube link, it took me just around 42 minutes to put together. Scratch that, it took my 11-year-old daughter, with some guidance from me, from start to finish. The only problem I have with assembly was the cable television tray, which I found wasn’t explained well in the guidelines.

Once assembled, I love the smooth look of this desk. I’m positive any of the many varied surfaces that it is available in would look terrific in any workplace, and the adjustable width makes it simple to fit it in even the smallest of office.

The quiet operation and height memory settings make it simple, efficient, and peaceful to switch between sitting and standing as often times as you desire throughout the day.

This desk is strong. It can hold up to 335 lbs even while in operation, so if you have a significant desktop computer (or want to rest on it for some reason) it has you covered. It will also evenly distribute weight no matter how out of balance the weight you put on it is, it will not wobble or wiggle.

 

in that video is quite kitted out as the desk we’re looking at today is pretty basic I tried to get as close to that as I could on uplifts site with similar configurations the flexi area desk we’re looking at today will run you about four hundred and ten dollars versus six hundred and fifty for a comparable desk from uplift I try to get as close as possible with the uplift design is really five inches longer however you can do a lot with five inches boom yes now for transparency flexi area did send this desk out for evaluation but as you ought to know by now doesn’t impact my review in any way the desktop here is 55 inches large 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not delivering till completion of April at the earliest the desktop is an inch thick but it’s this standard laminate as you can perhaps get lacking even any cable television grommets for go through the outdoors container

for the desktop was not damaged in any way which is absolutely strange due to the fact that I might shoot a 30-second b-roll montage of simply the damage and defects on this desktop scuffed scraped pitted just very rough guy if I had actually acquired this I ‘d have been on the phone with customer service immediately they did likewise handled to miss out on drilling the pilot holes where you can connect the control box to the desktop a lot of having to do that myself without accidentally drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface to the frame that’s a far cry from the embedded metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was really quite uncomplicated the entire thing came together in about 45 minutes and despite the fact that there’s cable televisions running to it from each component to support motorized function unusually definitely where any kind of cable management products whatsoever the frame on this unit is a single motor double phase design versus the dual motor three-stage design that comes requirement with the uplift desk this can be updated also to both the double stage double motor and a three-stage double motor which pushes the expense of the desk up

an additional 70 bucks the frame is designed for a max load of 154 pounds and it moves at a rate at an inch per second the height can vary from simply under 28 inches to simply over forty seven point 6 inches so a max I ‘d it is more than high enough even for me and I stay at 6 foot for this design does come basic with the control board that enables up-and-down movement plus 3 memory areas with an LED readout to tell you the desk height the single motor style uses this drive shaft assembly which has to be changed as the width of the desk is changed the motor operation itself while it might be slow is very quiet as in barely audible this outside a price would be the one benefit I would provide this unit over the uplift desk and I wish to take care here due to the fact that this isn’t a hit piece this desk is 240 dollars cheaper than the comparable uplift model over 35% less expensive even if you update this flexi spot test to the double motor three-stage design it still is available in a hundred and seventy dollars less expensive than the uplift but cheaper doesn’t indicate low-cost this desk is still over four hundred dollars if I had paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is solid even if max height I’ll definitely offer it that however the lateral stability of this desk the horizontal motion at this rate point it’s inappropriate it’s rub salt in the wound here they consist of a little security baffle this little steel piece that installs to the frame and covers a portion of this turning driveshaft when

this desk sees any lateral motion at all the drive shaft hits the noise and this baffle is absolutely frustrating to top things off I chose to include rolling casters to this desk this was a $30 upgrade and two of those four casters arrived damaged also my plan for this desk at this point is to lose the desk top and included entirely and replace it with a white laminate lemon table from Ikea and use it as an adjustable photo table which you can’t do this frame will accommodate desktops up to 63 inches broad and 31 and a half inches deep so this will roll around the studio make it simpler to movie items without having to adjust complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I found uplift initially that is an investment in quality workplace furnishings that will last you this at finest feels like a more affordable imitation of that it just does not feel quality and the difference in between this desk and my primary desk is night and day do do not hesitate to take a look at their site as well which also feels strangely similar to among their rivals there’s a wealth of devices you can get for the flexi spot desk as much as and including a foot massager and even a fixed exercise bike and I could spend another 10 minutes of our valuable time covering various alternatives and devices I could however I believe I’m better that they just sent a fundamental desk since as a standard desk I’m not a fan of the quality assurance at this price point and I do not think slapping on a bunch of bonus is the move when the core product isn’t what it must be they do use a 30-day trial if you’re just morbidly curious and they guarantee their desks for 3 years very desk is five years and uplift desk is 7 years if you are Flexispot E8 Test

in the market for a sit-stand desk they’re amazing mine’s been a life changer for me both in terms of video gaming and productivity but I would spend the additional money it’s gon na take to enter into a greater end producer like uplift desk or extremely desk and I haven’t personally used really desk items so I can’t speak on it but their reputation is great huge thanks to flexi area for sending this out for evaluation sadly I can not suggest this unit and for the record I’m a hundred percent sure they would have gladly changed the parts that I had an issue with viewing as how both the desktop and the casters showed up harmed however from a client viewpoint you ‘d most likely be really thrilled to get this in