Flexispot Standing Desk Evaluation …Flexispot Chair…
Cons: What I Didn’t Like About the Flexispot E7
Though the cons on this desk are very little, here are a couple of functions that I wasn’t necessarily a huge fan of:
The package that the desk can be found in was heavy, so bringing it inside was a group effort, but this is simply a repercussion of how sturdy the Flexispot is.
The convenient cable tray was a little bit confusing to set up. In the end, you eventually slip it under screws, which wasn’t extremely clear from the directions.
You will need to buy an anti-fatigue mat to remain comfy, but this is a great idea for any standing desks, so I can’t fault Flexispot for that.
When it showed up and I saw how heavy it was, I was both excited (given that this meant it was going to be durable) and also a little reluctant (since all of us know just how much of an obstacle putting together furnishings can be).
The good news is, with the help of a training YouTube link, it took me only around 42 minutes to put together. Scratch that, it took my 11-year-old daughter, with some supervision from me, from start to finish. The only hang-up I have with assembly was the cable television tray, which I found wasn’t explained well in the instructions.
As soon as put together, I love the smooth look of this desk. I’m confident any of the many varied surfaces that it is available in would look terrific in any office, and the adjustable width makes it simple to fit it in even the tiniest of office.
The peaceful operation and height memory settings make it simple, efficient, and peaceful to switch in between sitting and standing as often times as you want throughout the day.
Lastly, this desk is tough. It can hold up to 335 lbs even while in operation, so if you have a large desktop (or wish to sleep on it for some reason) it has you covered. It will also equally disperse weight no matter how unbalanced the weight you place on it is, it won’t wobble or wiggle.
in that video is quite kitted out as the desk we’re looking at today is quite fundamental I attempted to get as close to that as I could on uplifts website with comparable setups the flexi spot desk we’re looking at today will run you about four hundred and ten dollars versus six hundred and fifty for a similar desk from uplift I try to get as close as possible with the uplift design is really 5 inches longer however you can do a lot with 5 inches boom yes now for openness flexi area did send this desk out for review but as you must understand by now doesn’t impact my review in any way the desktop here is 55 inches broad 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not shipping up until completion of April at the earliest the desktop is an inch thick but it’s this fundamental laminate as you can perhaps get doing not have even any cable television grommets for travel through the outside carton
for the desktop was not harmed in any way which is absolutely unusual because I might shoot a 30-second b-roll montage of just the damage and defects on this desktop scuffed scraped pitted simply very rough guy if I had actually purchased this I ‘d have been on the phone with customer care instantly they did likewise handled to miss drilling the pilot holes where you can connect the control box to the desktop a great deal of having to do that myself without mistakenly drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was really quite uncomplicated the entire thing came together in about 45 minutes and despite the fact that there’s cables running to it from each component to support motorized function strangely absolutely where any type of cable television management products whatsoever the frame on this unit is a single motor dual phase style versus the dual motor three-stage design that comes requirement with the uplift desk this can be upgraded too to both the double phase double motor and a three-stage dual motor which pushes the cost of the desk up
an extra 70 bucks the frame is created for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can range from simply under 28 inches to just over forty seven point 6 inches so a max I ‘d it is more than tall adequate even for me and I stay at 6 foot for this design does come standard with the control board that enables up-and-down motion plus three memory areas with an LED readout to tell you the desk height the single motor design utilizes this drive shaft assembly which has to be adjusted as the width of the desk is changed the motor operation itself while it might be sluggish is extremely quiet as in barely audible this outside a rate would be the one advantage I would give this unit over the uplift desk and I want to take care here since this isn’t a hit piece this desk is 240 dollars cheaper than the comparable uplift design over 35% less expensive even if you update this flexi area test to the double motor three-stage design it still can be found in a hundred and seventy dollars less expensive than the uplift but less expensive does not imply low-cost this desk is still over four hundred dollars if I had actually paid over $400 for this desk I ‘d have an issue with that the front to back stability of this desk is solid even if max height I’ll definitely give it that however the lateral stability of this desk the horizontal motion at this cost point it’s unacceptable it’s rub salt in the wound here they include a little security baffle this little steel piece that mounts to the frame and covers a part of this turning driveshaft when
this desk sees any lateral motion at all the drive shaft strikes the sound and this baffle is absolutely shocking to leading things off I decided to add rolling casters to this desk this was a $30 upgrade and two of those 4 casters arrived harmed also my prepare for this desk at this point is to lose the desk top and featured all together and replace it with a white laminate lemon table from Ikea and use it as an adjustable picture table which you can’t do this frame will accommodate desktops up to 63 inches large and 31 and a half inches deep so this will roll around the studio make it simpler to film items without needing to adjust complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift initially that is a financial investment in quality workplace furnishings that will last you this at best feels like a more affordable replica of that it just doesn’t feel quality and the difference in between this desk and my primary desk is night and day do feel free to check out their site as well which likewise feels strangely similar to one of their competitors there’s a wealth of devices you can get for the flexi spot desk as much as and consisting of a foot massager and even a fixed stationary bicycle and I might spend another 10 minutes of our precious time covering numerous alternatives and accessories I could however I believe I’m happier that they only sent a basic desk since as a fundamental desk I’m not a fan of the quality assurance at this price point and I don’t think slapping on a lot of extras is the relocation when the core item isn’t what it must be they do offer a 30-day trial if you’re just morbidly curious and they service warranty their desks for three years very desk is five years and uplift desk is seven years if you are Flexispot Chair
in the market for a sit-stand desk they’re amazing mine’s been a life changer for me both in terms of video gaming and productivity however I would invest the extra money it’s gon na take to enter a greater end producer like uplift desk or really desk and I haven’t personally utilized very desk items so I can’t speak on it but their track record is very good big thanks to flexi spot for sending this out for evaluation sadly I can not suggest this unit and for the record I’m a hundred percent sure they would have gladly changed the parts that I had an issue with viewing as how both the desktop and the casters got here damaged however from a consumer viewpoint you ‘d probably be really thrilled to get this in