Flexispot 120 X 80 – 77% OFF Today Only

Flexispot Standing Desk Review …Flexispot 120 X 80…

Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are very little, here are a few features that I wasn’t always a huge fan of:

The bundle that the desk came in was heavy, so bringing it inside was a group effort, however this is just a consequence of how tough the Flexispot is.
The convenient cable television tray was a bit complicated to install. In the end, you eventually slip it under screws, which wasn’t extremely clear from the instructions.
You will require to buy an anti-fatigue mat to remain comfortable, but this is a good idea for any standing desks, so I can’t fault Flexispot for that.

When it showed up and I saw how heavy it was, I was both thrilled (because this meant it was going to be durable) and also a little reluctant (because we all understand just how much of an obstacle putting together furnishings can be).

Thankfully, with the help of an educational YouTube link, it took me just around 42 minutes to put together. Scratch that, it took my 11-year-old child, with some guidance from me, from start to finish. The only problem I have with assembly was the cable tray, which I found wasn’t explained well in the guidelines.

As soon as put together, I love the streamlined look of this desk. I’m confident any of the many varied surfaces that it can be found in would look great in any workplace, and the adjustable width makes it easy to fit it in even the smallest of office.

The peaceful operation and height memory settings make it simple, efficient, and quiet to switch between sitting and standing as many times as you desire throughout the day.

This desk is durable. It can hold up to 335 pounds even while in operation, so if you have a hefty home computer (or wish to take a nap on it for some reason) it has you covered. It will likewise equally disperse weight no matter how unbalanced the weight you place on it is, it won’t wiggle or wobble.

 

in that video is pretty kitted out as the desk we’re looking at today is pretty fundamental I attempted to get as close to that as I might on uplifts site with comparable configurations the flexi area desk we’re taking a look at today will run you about four hundred and ten dollars versus 6 hundred and fifty for a comparable desk from uplift I attempt to get as close as possible with the uplift design is really 5 inches longer however you can do a lot with five inches boom yes now for transparency flexi spot did send this desk out for evaluation however as you must understand by now does not impact my evaluation in any way the desktop here is 55 inches wide 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not delivering up until completion of April at the earliest the desktop is an inch thick however it’s this standard laminate as you can possibly get lacking even any cable grommets for travel through the outside container

for the desktop was not damaged in any way which is absolutely bizarre because I could shoot a 30-second b-roll montage of just the damage and defects on this desktop scuffed scraped pitted simply extremely rough male if I had acquired this I ‘d have been on the phone with customer service right away they did also handled to miss drilling the pilot holes where you can attach the control box to the desktop a lot of having to do that myself without accidentally drilling through the opposite of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface to the frame that’s a far cry from the embedded metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was actually quite uncomplicated the whole thing came together in about 45 minutes and despite the fact that there’s cable televisions running to it from each element to support motorized function strangely definitely where any kind of cable management products whatsoever the frame on this system is a single motor double stage design versus the dual motor three-stage style that comes standard with the uplift desk this can be updated also to both the double stage dual motor and a three-stage dual motor which presses the expense of the desk up

an extra 70 dollars the frame is developed for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can range from simply under 28 inches to simply over forty 7 point 6 inches so a max I ‘d it is more than tall enough even for me and I stay at 6 foot for this model does come standard with the control board that allows for up-and-down movement plus 3 memory areas with an LED readout to tell you the desk height the single motor design uses this drive shaft assembly which needs to be changed as the width of the desk is changed the motor operation itself while it might be sluggish is really peaceful as in barely audible this outside a cost would be the one advantage I would offer this unit over the uplift desk and I wish to be careful here because this isn’t a hit piece this desk is 240 dollars more affordable than the similar uplift model over 35% less expensive even if you upgrade this flexi area test to the dual motor three-stage design it still can be found in a hundred and seventy dollars less expensive than the uplift however more affordable does not indicate inexpensive this desk is still over four hundred dollars if I had actually paid over $400 for this desk I ‘d have an issue with that the front to back stability of this desk is solid even if max height I’ll absolutely provide it that but the lateral stability of this desk the horizontal motion at this price point it’s unacceptable it’s add insult to injury here they consist of a little security baffle this little steel piece that installs to the frame and covers a portion of this rotating driveshaft when

this desk sees any lateral motion at all the drive shaft hits the sound and this baffle is absolutely infuriating to leading things off I chose to add rolling casters to this desk this was a $30 upgrade and 2 of those 4 casters showed up harmed too my prepare for this desk at this moment is to lose the desk top and featured entirely and replace it with a white laminate lemon table from Ikea and utilize it as an adjustable image table which you can’t do this frame will accommodate desktops approximately 63 inches large and 31 and a half inches deep so this will roll around the studio make it much easier to film products without needing to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I found uplift initially that is a financial investment in quality office furniture that will last you this at best seems like a less expensive replica of that it just does not feel quality and the distinction between this desk and my main desk is night and day do feel free to have a look at their website also which likewise feels eerily similar to one of their competitors there’s a wealth of accessories you can get for the flexi area desk up to and consisting of a foot massager and even a fixed exercise bike and I might invest another 10 minutes of our valuable time covering various options and accessories I could but I think I’m happier that they only sent out a standard desk since as a fundamental desk I’m not a fan of the quality control at this price point and I don’t believe slapping on a bunch of additionals is the move when the core product isn’t what it ought to be they do offer a 30-day trial if you’re just morbidly curious and they guarantee their desks for three years really desk is 5 years and uplift desk is seven years if you are Flexispot 120 X 80

in the market for a sit-stand desk they’re amazing mine’s been a life changer for me both in terms of gaming and efficiency however I would invest the money it’s gon na require to get into a greater end producer like uplift desk or really desk and I haven’t personally used really desk items so I can’t speak on it however their credibility is excellent huge thanks to flexi spot for sending this out for review unfortunately I can not suggest this system and for the record I’m a hundred percent sure they would have gladly replaced the parts that I had an issue with viewing as how both the desktop and the casters got here harmed however from a customer viewpoint you ‘d probably be truly thrilled to get this in